Structural & Mechanical Testing

From static load evaluation to precision material testing, ACES supports the structural verification of aircraft seats, monuments, components, and interior assemblies. Capabilities include static load testing, tension and compression testing, slip-resistance evaluation, and cyclic fatigue/MTBF testing using specialized equipment and adaptable in-house test systems. Combining engineering expertise with controlled testing capabilities allows ACES to evaluate structural performance, document compliance with applicable requirements, and help customers move efficiently from test planning through certification.

Static load testing evaluates the ability of aircraft seats, monuments and other structural assemblies to withstand the loads associated with normal flight and emergency landing conditions.

Structures can be subjected to ultimate loads to verify that deformation does not adversely affect the integrity of the assembly and to demonstrate compliance with applicable requirements of 14 CFR §§ 23.561, 25.561, 27.561 and 29.561 .

Typical Test Articles

Aircraft Seats Seat assemblies can be evaluated under static loading conditions to demonstrate structural performance and compliance with applicable emergency landing load requirements.
Interior Monuments Large cabin structures such as galleys, cabinets, partitions, bulkheads and similar monuments can be tested to verify their ability to withstand required structural loads.
Depending on the installation and certification basis, structural compliance may be demonstrated through static or dynamic testing.

Applicable CFRs

Learn More

Tension, compression and shear testing are used to evaluate the strength and mechanical properties of aircraft materials, components and structural specimens under different loading conditions.

ACES uses an Instron Load Frame to perform controlled tension, compression, shear and bending tests and support compliance with applicable material-strength requirements of 14 CFR §§ 23.613, 25.613, 27.613 and 29.613 .

Instron Testing Capabilities

Tensile Testing Measures the response and strength of a material or component when subjected to a pulling load.
Compression Testing Evaluates material or component behavior under compressive loading.
Shear Testing Evaluates resistance to forces acting parallel to the material or test specimen.
V-Notch Shear Provides shear-property evaluation using a notched specimen configuration.
3-Point Bending Evaluates flexural behavior by loading a specimen between two supporting points.
4-Point Bending Provides flexural testing using two loading points to evaluate bending performance over a defined region.

Applicable CFRs

Learn More

Slip resistance testing measures the slip-resistant properties of flooring and walking-surface materials intended for use aboard aircraft.

Testing helps determine whether the selected material provides adequate resistance to slipping under applicable operating conditions and can be used to demonstrate compliance with 14 CFR § 25.793.

This capability can support evaluation of new flooring materials, replacement surfaces and changes to existing aircraft interior finishes where slip resistance is a certification consideration.

Applicable CFRs

Learn More

Cyclic testing is used to evaluate the durability, service life and Mean Time Between Failure (MTBF) characteristics of aircraft materials, mechanisms and interior components.

ACES has designed and built autonomous cyclic testing systems capable of repeatedly operating or loading a test article over a defined number of cycles, allowing long-term durability and performance to be evaluated under controlled conditions.

Typical Applications

  • Aircraft seat mechanisms
  • Flooring materials and assemblies
  • Galleys and galley components
  • Countertops and work surfaces
  • Interior mechanisms and components
  • Other aircraft cabin materials and assemblies

Because the test setups are designed and fabricated in-house, ACES can adapt the equipment to accommodate projects of varying sizes and configurations while supporting efficient turnaround times.

Learn More